Dell Force10 MXL Blade - Page 500

500 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History
Usage Information
When the offset metric is applied to an interface, that value takes precedence over an offset value that
is not extended to an interface.
Related
Commands
output-delay
Set the interpacket delay of successive packets to the same neighbor.
Syntax
output-delay delay
To return to the switch software defaults for interpacket delay, use the no output-delay command.
Parameters
Default
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command is intended for low-speed interfaces.
prefix-list-name
Enter the name of an established Prefix list to determine which incoming routes will
be modified.
offset
Enter a number from zero (0) to 16 to be applied to the incoming route metric
matching the access list specified.
If you set an offset value to zero (0), no action is taken.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
ip prefix-list Enters PREFIX-LIST mode and configures a prefix list.
delay
Specify a number of milliseconds as the delay interval.
Range: 8 to 50
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module