Dell Force10 MXL Blade - Page 501

Routing Information Protocol (RIP) | 501
passive-interface
Suppress routing updates on a specified interface.
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command History
Usage Information
Although the passive interface neither sends nor receives routing updates, the network on that interface
is still included in RIP updates sent via other interfaces.
Related
Commands
redistribute
Redistribute information from other routing instances.
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information originate command.
interface
Enter the following information:
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
neighbor Enables RIP for a specified network.
network Defines a neighbor.
connected Enter the keyword connected to specify that information from active routes on interfaces
is redistributed.
static Enter the keyword static to specify that information from static routes is redistributed.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module