Dell Force10 S2410-01-10GE-24P - DVLAN Configuration Example

VLANs | 231
DVLAN configuration example
The example here shows how to configure VLANs so that VLAN traffic from switches R4 and R5 is
encapsulated in frames tagged with VLAN 3 going through switch R7.
Figure 14-194. DVLAN Example Topology
Configure switch R4:
Figure 14-195. VLAN-Stack Configuration Sequence on R4
R4 (Config)#dvlan-tunnel ethertype vman
!---------Access port:-----------!
R4 (Config)#interface 1/0/2
R4 (Interface 1/0/2)#no shutdown
Force10 (Interface 1/0/1)#vlan pvid 10
Force10 (Interface 1/0/1)#vlan participation exclude 1
Force10 (Interface 1/0/1)#vlan participation include 10
R4 (Interface 1/0/2)#mode dvlan-tunnel
R4 (Interface 1/0/2)#exit
!---------Trunk port:----------!
R4 (Config)#interface 1/0/3
R4 (Interface 1/0/3)#no shutdown
R4 (Interface 1/0/3)#mode dvlan-tunnel
R4 (Interface 1/0/3)#exit