Dell Force10 Z9000 - Page 389

Interfaces | 389
To add a physical interface to a port channel, use these commands in the following sequence in the
INTERFACE mode of a port channel:
To view the port channel’s status and channel members in a tabular format, use the
show interfaces
port-channel brief
command in the EXEC Privilege mode.
Figure 19-11. show interfaces port-channel brief Command Example
Step Command Syntax Command Mode Purpose
1
channel-member interface INTERFACE
PORT-CHANNEL
Add the interface to a port channel.
The interface variable is the physical interface
type and slot/port information.
2
show config
INTERFACE
PORT-CHANNEL
Double check that the interface was added to
the port channel.
FTOS#show int port brief
LAG Mode Status Uptime Ports
1 L2L3 up 00:06:03 Gi 13/6 (Up) *
Gi 13/12 (Up)
2 L2L3 up 00:06:03 Gi 13/7 (Up) *
Gi 13/8 (Up)
Gi 13/13 (Up)
Gi 13/14 (Up)
FTOS#