Dell Force10 Z9000 - Clear Line; Configure

clear line
Reset a terminal line.
C-Series, E-Series, S-Series, Z-Series
Syntax
clear line {line-number | aux 0 | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the system. Range:
0 to 11.
aux 0 Enter the keywords aux 0 to reset the auxiliary port.
NOTE: This option is supported on the E-Series only.
console 0 Enter the keywords console 0 to reset the console port.
vty number Enter the keyword vty followed by a number to clear a terminal line.
Range: 0 to 9.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
configure
Enter CONFIGURATION mode from EXEC Privilege mode.
C-Series, E-Series, S-Series, Z-Series
Syntax
configure [terminal]
Parameters
terminal (OPTIONAL) Enter the keyword terminal to specify that you are
configuring from the terminal.
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
103