Dell Force10 Z9000 - Match Mac Dot1 P; Match Mac Vlan

match mac dot1p
Configure a match criterion for a class map based on a dot1p value.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
match mac dot1p {dot1p-list}
Parameters
dot1p-list Enter a dot1p value. The range is 0 to 7.
Defaults none
Command Modes CLASS-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Available on the C-Series and S-Series.
Version 7.5.1.0 Added support for the DSCP Marking option.
pre-Version
7.4.1.0
Introduced.
Usage
Information
You must enter the class-map command in order to access this command. After the class
map is identified, you can configure the match criteria.
Related
Commands
class-map – identifies the class map.
match mac vlan
Configure a match criterion for a class map based on VLAN ID.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
match mac vlan number
Parameters
number Enter the VLAN ID. The range is 1 to 4094.
Defaults none
Command Modes CLASS-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced.
1200