Dell Force10 Z9000 - Page 1478

Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
The following describes the show vrrp brief command shown in the Example below.
Item Description
Interface Lists the interface type, slot and port on which the VRRP group is
configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface. If the track
command is configured to track that interface and the interface is
disabled, the cost is subtracted from the priority value assigned to
the interface.
Pre States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
• N = Preempt is not enabled.
State Displays the operational state of the interface by using one of the
following:
• NA/IF (the interface is not available).
• MASTER (the interface associated with the MASTER router).
• BACKUP (the interface associated with the BACKUP router).
Master addr Displays the IP address of the MASTER router.
Virtual addr(s) Displays the virtual IP addresses of the VRRP routers associated
with the interface.
Example (Brief)
FTOS>Interface Grp Pri Pre State Master addr Virtual addr(s)
Description----------------------------------------------------
--------
Gi 10/37 1 100 Y Master 200.200.200.200 200.200.200.201
Gi 10/37 2 100 Y Master 200.200.200.200 200.200.200.202
200.200.200.203 Description
Gi 10/37 3 100 Y Master 1.1.1.1 1.1.1.2
Gi 10/37 4 100 Y Master 200.200.200.200 200.200.200.206
200.200.200.207 ... short desc
Gi 10/37 254 254 Y Master 200.200.200.200 200.200.200.204
1478