Dell Force10 Z9000 - Set Level

All routes with the NO_EXPORT (0xFFFFFF01) community attribute
must not be advertised outside a BGP confederation boundary.
none Enter the keyword none to remove the community attribute from
routes meeting the route map criteria.
additive (OPTIONAL) Enter the keyword additive to add the communities to
already existing communities.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
ip community-list – configures community access list.
match community – redistributes routes that match the COMMUNITY attribute.
neighbor send-community – assigns the COMMUNITY attribute.
show ip bgp community – displays BGP community groups.
show ip community-lists – displays configured Community access lists.
set level
Configure a filter to specify the IS-IS level or OSPF area to which matched routes are redistributed.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-
area}
To remove a set level condition, use the no set level {backbone | level-1 |
level-1-2 | level-2 | stub-area} command.
Parameters
backbone Enter the keyword backbone to redistribute matched routes to the
OSPF backbone area (area 0.0.0.0).
level-1 Enter the keyword level-1 to redistribute matched routes to IS-IS
Level 1.
level-1-2 Enter the keyword level-1-2 to redistribute matched routes to IS-
IS Level 1 and Level 2.
level-2 Enter the keyword level-2 to redistribute matched routes to IS-IS
Level 2.
296