Dell Force10 Z9000 - Buffer-Profile (Configuration)

Related
Commands
buffer-profile (Configuration) – creates a buffer profile that can be applied to an interface.
buffer-profile (Configuration)
Create a buffer profile that can be applied to an interface.
C-Series, S-Series, Z-Series
Syntax
buffer-profile {{fp | csf} profile-name | global {1Q|4Q}
Parameters
fp Enter the keyword fp to create a buffer profile for the Field
Processor.
csf Enter the keyword csf to create a buffer profile for the Switch Fabric
Processor.
profile-name Create a name for the buffer profile.
global Apply one of two pre-defined buffer profiles to all of the port-pipes in
the system.
1Q Enter the keyword 1Q to choose a pre-defined buffer profile for single
queue (for example, non-QoS) applications.
4Q Enter the keyword 4Q to choose a pre-defined buff fer profile for four
queue (for example, QoS) applications.
Defaults global 4Q
Command Modes CONFIGURATION
Command History
Version 8.3.11.0 Introduced on the Z9000.
Version 7.8.1.0 Added the global keyword.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Usage
Information
The buffer-profile global command fails if you have already applied a custom
buffer-profile on an interface. Similarly, when you configure
buffer-profile global,
you cannot not apply buffer-profile on any interface.
If the default buffer-profile (4Q) is active, FTOS displays an error message instructing you to
remove the default configuration using the no buffer-profile global command.
You must reload the system for the global buffer-profile to take effect.
Related
Commands
buffer (Buffer Profile) – allocates an amount of dedicated buffer space, dynamic buffer space,
or packet pointers to queues 0 to 3.
576