Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on C-Series, E-Series, and S-Series
Example
FTOS#show garp timers
GARP Timers Value (milliseconds)
----------------------------------------
Join Timer 200
Leave Timer 600
LeaveAll Timer 10000
FTOS#
Related
Commands
garp timers – sets the intervals (in milliseconds) for sending GARP messages.
show gvrp
Display the GVRP configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show gvrp [brief | interface]
Parameters
brief (OPTIONAL) Enter the keyword brief to display a brief summary of
the GVRP configuration.
interface
(OPTIONAL) Enter the following keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/ port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel
followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
656
To Next Page
Loading...
