Steps
1.
NOTE: Place the system board on a clean and flat surface.
Replace the I/O board,USB board, and heat sink.
2. Turn the system board over.
3. Align the screw holes on the system board with the screw holes on the palm-rest and keyboard assembly.
4. Replace the four (M2x4) screws that secure the system board to the palm-rest and keyboard assembly.
NOTE: Move in clock-wise direction to connect the cables to the system board.
5. Open the latch and connect the display cable from the system board.
6. Adhere the tape that secures the display cable to the system board.
7. Open the latch and connect the power-adapter port cable from the system board.
8. Connect the speaker cable from the system board.
9. Open the latch and connect the keyboard cable from the system board.
10. Open the latch and connect the keyboard-backlight cable from the system board.
11. Open the latch and connect the touchpad cable from the system board.
12. Open the latch and connect the power-button cable from the system board.
Next steps
1. Install the left fan.
2. Install the right fan.
3. Install the memory module.
4. Install the wireless card.
Removing and installing components
45
To Next Page
Loading...
