Steps
1. Place the heat sink on the system board and align the screw holes on the heat sink with the screw holes on the system
board.
2. Replace the six screws (M2x4) that secure the heat sink to the system board.
3. Turn the system board over and align the screw holes on the system board with the screw holes on the palm-rest and
keyboard assembly.
Next steps
1. Install the system board.
2. Install the left fan.
3. Install the right fan.
4. Install the memory module.
5. Install the wireless card.
6. Install the solid-state drive 2.
7. Install the solid-state drive 1.
8. Install the rear cover
9. Install the battery.
10. Install the base cover.
11. Follow the procedure in After working inside your computer.
48
Removing and installing components
To Next Page
Loading...
