Dell G15 5525 - Page 39

NOTE: After removing the screws, lift the system board from the top left and right sides of the heat sink. Ensure the
connectors are released from the ports and pins on the left and right sides of your computer.
NOTE: Place the system board on a clean and flat surface.
CAUTION: Do not lift the system-board assembly holding the USB board, ethernet and audio board , or the
bottom side of the system board.
15. After performing all the above steps, lift the system board off the palm-rest and keyboard assembly along with the ethernet
and audio board , USB board, and fan and heat-sink assembly.
16. Turn the system board over and remove ethernet and audio board, USB board, and fan and heat-sink assembly.
17. After performing all the above steps, you are left with system board.
Removing and installing components
39