2. Gently pry and release the front-cover tabs sequentially from the top.
3. Move the front cover outward from the chassis.
4. Disconnect the front-LED cable from the connector on the front cover.
Identifier GUID-03D5186C-15D4-486A-A02A-C2CD5A75BDBD
Status Released
Installing the front cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the front cover and provides a visual representation of the installation procedure.
Steps
1. Place the computer in an upright position.
2. Connect the front-LED cable to the connector on the front cover.
3. Align the front-cover tabs with the slots on the chassis.
4. Rotate the front cover towards the chassis and snap it into place.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
18
Removing and installing components
To Next Page
Loading...
