About this task
The following images indicate the location of the LED daughter board and provides a visual representation of the removal procedure.
Steps
1. Slide the LED daughter board in place on the system board.
2. Replace the screw (M2x3) that secures the LED daughter board to the system board.
3. Connect the light-bar cable and the front-LED cable to their respective connectors on the LED daughter board.
Next steps
1. Install the left-side cover.
2. Follow the procedure in After working inside your computer.
Identifier
GUID-46B53388-5C4F-4861-92E0-6AE357EE9CBF
Status Released
System board
Identifier
GUID-0D33162E-A036-49D7-97CC-C79D09691FD5
Status Released
Removing the system board
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Your computer’s Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup
program after you replace the system board.
NOTE: Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program.
You must make the appropriate changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
Removing and installing components 51
To Next Page
Loading...
