6. Remove the left fan.
7. Remove the right fan.
8. Remove the solid-state drive/Intel Optane.
9. Remove the hard drive.
10. Remove the I/O board.
11. Remove the touchpad.
12. Remove the speakers.
13. Remove the heat sink.
14. Remove the display assembly.
15. Remove the power-adapter port.
16. Remove the system board.
NOTE: The system board can be removed with the heat sink attached.
About this task
After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.
Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Place the palm-rest and keyboard assembly on a flat surface.
Removing and installing components
59
To Next Page
Loading...
