Replacing the AC Adapter Connector
1. Follow the procedures in Before You Begin.
2. Place the AC adapter connector in the computer base.
3. Route the AC adapter connector cable through the routing guide.
4. Replace the I/O board (see Replacing the I/O Board).
5. Replace the left support bracket (see Replacing the Left Support Bracket).
6. Follow the instructions from step 4 to step 21 in Replacing the System Board.
7. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
