Dell Inspiron 1210 - Replacing the Display Assembly

Back to Contents Page
 Replacing the Display
Dell™Inspiron™1210ServiceManual
Replacing the Display Assembly
Replacing the Display Bezel
Replacing the Display Panel

Replacing the Display Assembly

1. Followtheinstructionsin"BeforeYouBegin"onpage9.

2. Remove the palm rest. See Replacing the Palm Rest.

3. Pull the display cable tab to disconnect the display cable from the system board connector.

4. Disconnect the 2-in-1 camera and LVDS cable from the system board connector.

5. Remove the four M2.5 x 3-mm screws from the display hinges.

6. Lift and remove the display assembly from the computer base.

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTE: Note how the display cable and the 2-in-1 camera and LVDS cable have been connected on the system board.
1
display
2
M2.5 x 3-mm screws (4)
3
2-in-1 cable: camera end
4
2-in-1 cable: LVDS end