Dell Inspiron 1210 - Using Your Inspiron Laptop; Right Side Features

8. Replace the two rubber bumpers at the bottom of the display bezel on either side.

9. Replace the display assembly (see Followtheinstructionsin"BeforeYouBegin"onpage9.).
Replacing the Display Panel

1. Remove the display assembly (see Followtheinstructionsin"BeforeYouBegin"onpage9.).

2. Remove the display bezel (see Replacing the Display Bezel).

3. Remove the six M2.5 x 3-mm screws securing the display panel.

4. Disconnect the cables from the connectors on either side of the inverter board and the 2-in-1 camera and LVDS cable from the connector on the camera
board.

5. Remove the display panel.
1
M2.5 x 3-mm screws (6)
2
inverter board connectors (2)
3
connector on the camera board


NOTE: Note how the cables have been routed to the display panel.
1
2-in-1 camera and LVDS cable