Replacing the I/O board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the I/O board on the palm-rest assembly.
2 Align the screw hole on the I/O board with the screw hole on the palm-
rest assembly.
3 Replace the screw that secures the I/O board to the palm-rest assembly.
4 Connect the power and volume-buttons board-cable and coin-cell
battery-cable to the I/O board.
5 Connect the I/O-board cable to the I/O board.
6 Adhere the tape that secures the power and volume-buttons board-cable
to the palm-rest assembly.
7 Adhere the tape that secures the I/O-board cable to the I/O board.
Post-requisites
1 Replace the wireless card.
2 Replace the battery.
3 Replace the base cover.
66
To Next Page
Loading...
