Replacing the display panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the display panel on a flat surface.
2 Replace the sensor board.
3 Replace the camera.
4 Turn over the display-panel assembly.
5 Route the display cable through the routing guides inside the hinge
covers.
6 Align the display-panel assembly with the display back-cover and
antenna assembly and gently snap the display-panel assembly into place.
Post-requisites
1 Replace the display assembly.
2 Replace the battery.
3 Replace the base cover.
87
To Next Page
Loading...
