CAUTION: To prevent data loss, do not remove the solid-state drive while the computer is turned on or in
sleep state.
2. Remove the base cover.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed.
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
ā M.2 2230 solid-state drive + M.2 2230 mounting bracket
ā M.2 2280 solid-state drive
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
removal procedure.
Steps
1. Peel the Mylar that covers the M.2 2230 solid-state drive and the solid-state drive bracket.
2. Lift the Mylar that covers the M.2 2230 solid-state drive and the solid-state drive bracket.
3. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive bracket to the palm-rest and keyboard assembly.
18
Removing and installing components
To Next Page
Loading...
