4. Slide and lift the M.2 2230 solid-state drive assembly off the M.2 solid-state drive slot.
5. Flip over the M.2 2230 solid-state drive assembly.
6. Remove the screw (M2x2) that secures the M.2 2230 solid-state drive to the M.2 2230 solid-state drive bracket.
7. Lift the M.2 2230 solid-state drive off the solid-state drive bracket.
Installing the M.2 2230 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE: This procedure applies if you are installing a M.2 2230 solid-state drive.
NOTE: The M.2 card installed on your computer will depend on the configuration ordered. The supported card
configurations on the M.2 card slot are:
ā M.2 2230 solid-state drive + M.2 2230 mounting bracket
ā M.2 2280 solid-state drive
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
The following image(s) indicate the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Removing and installing components
19
To Next Page
Loading...
