Replacing the solid-state drive
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
Topics:
• Procedure
• Post-requisites
Procedure
1. Slide the solid-state drive firmly into the slot on the system board at an angle and gently press the solid-state drive down
until it snaps into position.
NOTE: Ensure that the solid-state drive is firmly seated.
2. Press the other end of the solid-state drive and replace the screw (M2x3) that secures the solid-state drive to the palm-rest
assembly.
Figure 5. Replacing solid-state drive
1.
screw 2. solid-state drive
3. solid-state drive slot 4. system board
8
18 Replacing the solid-state drive
To Next Page
Loading...
