Removing the speakers
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
Procedure
1. Disconnect the speaker cable from the system board.
2. Peel off the pieces of tape that secure the speaker cable to the palm-rest assembly.
3. Remove the speaker cable from the routing guides on the palm-rest assembly.
4. Note the position of the rubber grommets before lifting the speaker.
5. Remove the speakers from the alignment posts and lift the speakers off the palm-rest assembly.
Figure 12. Removing the speakers
1.
system board 2. speaker cable
15
30 Removing the speakers
To Next Page
Loading...
