Removing the display assembly
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the wireless card.
Procedure
1. Peel off the pieces of tape that secure the display cable and touch-screen board-cable to the system board.
2. Open the latches to disconnect the display cable and the touch-screen board-cable from the system board.
Figure 21. Disconnecting the cables
1.
antenna cables (2) 2. display cable
3. touch-screen board-cable 4. latch
5. tape (2)
3. Turn the computer over and open the display as far as possible.
31
Removing the display assembly 53
To Next Page
Loading...
