Replacing the camera
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Connect the camera cable to the camera module.
2. Adhere the tape that secures the camera cable to the camera module.
3. Using the alignment post place the camera module on the display panel and snap it into place.
Post-requisites
1. Follow the procedure from step 4 to step 6 in “Replacing the display panel”.
2. Replace the display assembly.
3. Replace the battery.
4. Replace the base cover.
44
76 Replacing the camera
To Next Page
Loading...
