Removing the display cable
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the base cover.
2. Remove the battery.
3. Remove the display assembly.
4. Follow the procedure from step 1 to step 3 in “Removing the display panel”.
5. Remove the camera.
Procedure
1. Peel off the tape and open the latch to disconnect the display cable from the display panel.
2. Peel off the sensor-board cable tape and disconnect the sensor-board cable.
3. Open the connector latch and disconnect the display cable.
4. Note the display cable routing and remove the display cable from the routing guides on the display panel.
5. Lift the display cable off the display panel.
45
Removing the display cable 77
To Next Page
Loading...
