Replacing the power-button
board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Procedures
1 Slide the power-button board under the tab on the palm rest and align
the screw hole on the power-button board with the screw hole on the
palm-rest assembly.
2 Replace the screw that secures the power-button board to the palm-rest
assembly.
3 Slide the power-button board cable through the slot on the palm-rest
assembly.
4 Turn the palm-rest assembly over.
Post-requisites
1 Follow the procedure from step 4 to step 11 in “Replacing the palm rest”.
2 Replace the keyboard.
3 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
4 Replace the base cover.
5 Replace the battery.
45
To Next Page
Loading...
