2 Place the base cover on the palm-rest assembly and route the optical-drive
cable through the slot on the palm-rest assembly.
3 Slide the tabs on the base cover into the slots on the palm-rest assembly, and
snap the base cover into place.
4 Slide the optical-drive cable into the connector on the system board and press
down the latch to secure the cable.
5 Replace the three screws (M2x5) that secure the base cover to the palm-rest
assembly.
6 Close the display, and turn the computer over.
7 Replace the three screws (M2x2) that secure the base cover to the palm-rest
assembly.
8 Replace the two screws (M2x5) that secure the base cover to the palm-rest
assembly.
9 Replace the eight screws (M2.5x8) that secure the base cover to the palm-rest
assembly.
31
To Next Page
Loading...
