Replacing the status-light board
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
www.dell.com/regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Align the screw hole on the status-light board with the screw hole on the palm rest and keyboard assembly.
2. Replace the screw (M2x3) that secures the status-light board to the palm rest and keyboard assembly.
3. Slide the status-light board cable into the connector on the status-light board and close the latch to secure the cable.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
28
42 Replacing the status-light board
To Next Page
Loading...
