Steps
1. Remove the two screws (M2x3) that secure the power-button with fingerprint reader to the palm-rest and keyboard
assembly.
2. Lift the power-button with fingerprint reader, along with the fingerprint-reader cable, off the slot on the palm-rest and
keyboard assembly.
3. Disconnect the fingerprint-reader cable from the palm-rest and keyboard assembly.
Installing the power-button with fingerprint reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: This procedure is applicable only when you are installing a power-button with fingerprint reader into your computer.
The following image indicates the location of the power-button with fingerprint reader and provides a visual representation of
the installation procedure.
48
Removing and installing components
To Next Page
Loading...
