Steps
1. Open the display-cable connector latch, and disconnect the display cable from the system board.
2. Remove the four screws (M2.5x4) that secure the right display hinge to the system board and palm-rest and keyboard
assembly.
3. Open the hinge at an angle of 90 degrees.
4. Remove the two screws (M2x4) that secure the USB Type-C bracket to the system board and palm-rest and keyboard
assembly.
5. Lift the USB Type-C port bracket off the system board and palm-rest and keyboard assembly.
6. Open the latch, and disconnect the keyboard-backlight cable from the system board.
Removing and installing components
51
To Next Page
Loading...
