Steps
1. Peel off the mylar covering the fingerprint-reader cable.
2. Remove the screw (M2x3) that secures the power-button with fingerprint reader to the palm-rest and keyboard assembly.
3. Lift the power-button with fingerprint reader, along with the fingerprint-reader cable, off the palm-rest and keyboard
assembly.
Installing the power-button with fingerprint reader
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE: This procedure is applicable only when you are installing a power-button with fingerprint reader into your computer.
The following image indicates the location of the power-button with fingerprint reader and provides a visual representation of
the installation procedure.
56
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
