Figure 41. Installing the USB board
Steps
1. Position the USB board near the USB-board cable and ensure that the USB-board cable latch of the USB board is visible.
2. Fold the USB-board cable towards the USB board.
3. Connect the USB-board cable to its connector on the USB board and close the latch.
4. Flip over the USB board and fold the cable back towards the palm-rest and keyboard assembly.
5. Replace the screw (M2x3) that secures the USB board to the palm-rest and keyboard assembly.
6. Connect the fingerprint-reader cable to the USB board and close the latch.
74
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
