Figure 43. Removing the power button with an optional fingerprint reader
Steps
1. Remove the screw (M2x3) that secures the power button to the palm-rest and keyboard assembly.
2. Peel back the tape that secures the fingerprint-reader cable to the palm-rest and keyboard assembly.
NOTE:
This step is only applicable for computers that are shipped with the power button with an optional fingerprint
reader.
3. Lift the power button off the palm-rest and keyboard assembly.
Installing the power button
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
Removing and installing Field Replaceable Units (FRUs)
77
To Next Page
Loading...
