Replacing the I/O board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more safety
best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Slide the I/O-board cable into the connector on the I/O board and close the
latch to secure the cable.
2 Adhere the tape to secure the I/O-board cable to the I/O board.
3 Turn the I/O board over.
4 Align the screw hole on the I/O board with the screw hole on the palm-rest
assembly.
5 Replace the screw that secures the I/O board to the palm-rest assembly.
Post-requisites
1 Follow the procedure from step 3 to step 7 in “Replacing the base cover”.
2 Replace the keyboard.
3 Follow the procedure from step 4 to step 5 in “Replacing the optical drive”.
4 Replace the battery.
22
Replacing the I/O board 52
To Next Page
Loading...
