Replacing the power-adapter
port
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your computer,
follow the instructions in After working inside your computer. For more safety
best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1 Slide the power-adapter port into the slot on the palm-rest assembly.
2 Replace the screw that secures the power-adapter port to the palm-rest
assembly.
3 Route the power-adapter port cable along its routing guides on the palm-rest
assembly.
Post-requisites
1 Replace the display assembly.
2 Replace the system board.
3 Replace the heat-sink assembly.
4 Replace the IO board.
5 Replace the wireless card.
6 Replace the memory module.
7 Follow the procedure from step 3 to step 5 in “Replacing the hard drive”.
8 Follow the procedure from step 3 to step 7 in “Replacing the base cover”.
34
Replacing the power-adapter port 79
To Next Page
Loading...
