Replacing the Bluetooth Board
1. Follow the procedures in Before You Begin.
2. Align the Bluetooth board with the slot on the palm rest and adhere the Bluetooth board on the palm rest.
3. Route the Bluetooth board cable through the routing guide and connect it to the system board connector.
4. Replace the Bluetooth card (see Replacing the Bluetooth Card).
5. Replace the keyboard (see Replacing the Keyboard).
6. Replace the center control cover (see Replacing the Center Control Cover).
7. Replace the hard drive (see Replacing the Hard Drive).
8. Replace the memory module(s) (see Replacing the Memory Module(s)).
9. Replace the module cover (see Replacing the Module Cover).
10. Replace the battery (see Replacing the Battery).
Back to Contents Page
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
To Next Page
Loading...
