Dell Inspiron 15 AMD - Removing the Module Cover; Replacing the Module Cover

Back to Contents Page
 Module Cover
Dell™Inspiron™1546ServiceManual
Removing the Module Cover
Replacing the Module Cover




Removing the Module Cover

1. Follow the procedures in Before You Begin.

2. Remove the battery (see Removing the Battery).

3. Loosen the four captive screws that secure the module cover to the computer base.

4. Lift the module cover off the computer at an angle as shown in the figure.
Replacing the Module Cover

1. Follow the procedures in Before You Begin.

2. Align the tabs on the module cover with the slots on the computer base and gently place it in position.

3. Tighten the four captive screws that secure the module cover to the computer base.

4. Replace the battery (see Replacing the Battery).

Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
1
module cover tabs (4)
2
module cover
3
captive screws (4)


CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.