Speaker board
Removing the speaker board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
About this task
The following image(s) indicate the location of the speaker board and provides a visual representation of the removal procedure.
Steps
1. Disconnect the display-speaker cable from the speaker board.
2. Using the pull tab, disconnect the speaker-board cable from the speaker board.
3. Remove the two screws (M2x1.8) that secure the speaker board to the palm-rest and keyboard assembly.
4. Lift the speaker board off the palm-rest and keyboard assembly.
Installing the speaker board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
68
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
