8. Lift the latch and disconnect the keyboard-backlight cable from the system board.
9. Remove the two screws (M2x4) that secure the USB Type-C bracket to the system board.
10. Lift the USB Type-C bracket off the system board.
11. Remove the two screws (M2x2) that secure the system board to the palm-rest and keyboard assembly.
12. Lift the system board off the palm-rest and keyboard assembly.
Installing the system board
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image indicates the connectors on your system board.
1. Touch-screen cable connector
2. Display-cable connector
3. Battery-cable connector
4. Keyboard-backlight cable connector
5. Keyboard-cable connector
6. Touchpad-cable connector
7. Speaker-board cable connector
8. Speaker-cable connector
9. M.2 solid-state drive connector
10. M.2 wireless-card connector
11. I/O-board cable connector
12. Fan-cable connector
The following image(s) indicate the location of the system board and provides a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
75
To Next Page
Loading...
