Steps
1. Remove the two screws (M2.5x5) that secure the left display hinge to the system board.
2. Open the left display hinge at an angle of 90 degrees.
3. Remove the two screws (M2.5x5) that secure the right display hinge to the system board.
4. Open the right display hinge at an angle of 90 degrees.
5. Peel the tape that secures the display-cable connector latch to the system board.
6. Open the latch and disconnect the display cable from the system board.
7. Remove the display cable from the routing guides on the palm-rest and keyboard assembly.
8. At an angle, gently lift the palm-rest and keyboard assembly off the display assembly.
34
Removing and installing components
To Next Page
Loading...
