Steps
1. Disconnect the speaker (tweeter) cable from the system board.
2. Peel the clear adhesive tape off the display-cable connector.
3. Open the latch and disconnect the display cable from the system board.
4. Remove the two screws (M2x5) that secure the Type-C port bracket to the system board.
5. Lift the Type-C port-bracket off the system board.
6. Open the latch and disconnect the keyboard cable from the system board.
7. Open the latch and disconnect the keyboard-backlight cable from the system board.
8. Peel the Mylar off the speaker (woofer) cable.
9. Disconnect the speaker (woofer) cable from the system board.
46
Removing and installing components
To Next Page
Loading...
