Replacing the Memory Module(s) | 23
Replacing the Memory Module(s)
WARNING: Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 9.
After working inside your computer, follow the instructions in "After Working
Inside Your Computer" on page 11. For additional safety best practices information,
see the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
Procedure
1 Align the notch on the memory module with the tab on the
memory-module connector.
2 Slide the memory module firmly, at a 45-degree angle into the connector,
and press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
Postrequisites
1 Replace the base cover. See "Replacing the Base Cover" on page 21.
2 Replace the battery. See "Replacing the Battery" on page 13.
book.book Page 23 Friday, December 14, 2012 3:32 PM
To Next Page
Loading...
