Replacing the camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
NOTE: These instructions are only applicable for laptop with non-
touchscreen display.
1 Using the alignment post, adhere the camera to the display back-cover.
2 Connect the camera cable to the camera connector.
Post-requisites
1 Replace the display bezel.
2 Replace the display assembly.
3 Replace the power-adapter port.
4 Replace the system board.
5 Replace the heat-sink assembly.
6 Replace the I/O board.
7 Follow the procedure from step 3 to step 8 in “Replacing the computer
base”.
8 Follow the procedure from step 4 to step 7 in “Replacing the optical
drive”.
9 Replace the keyboard.
10 Replace the memory modules.
11 Replace the wireless card.
12 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
13 Replace the base cover.
14 Replace the battery.
100
To Next Page
Loading...
