Replacing the power-adapter
port
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Procedure
1 Slide the power-adapter port into the slot on the palm-rest assembly.
2 Replace the screw that secures the power-adapter port to the palm-rest
assembly.
3 Route the power-adapter-port cable through the routing guides on the
palm-rest assembly.
4 Adhere the tape that secures the power-adapter port to the palm-rest
assembly.
Post-requisites
1 Replace the system board.
2 Replace the heat-sink assembly.
3 Replace the I/O board.
4 Follow the procedure from step 3 to step 8 in “Replacing the computer
base”.
5 Follow the procedure from step 4 to step 7 in “Replacing the optical
drive”.
6 Replace the keyboard.
7 Replace the memory modules.
8 Replace the wireless card.
9 Follow the procedure from step 4 to step 6 in “Replacing the hard drive”.
10 Replace the base cover.
11 Replace the battery.
73
To Next Page
Loading...
