Replacing the display panel
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Place the display panel on a flat surface.
2 Replace the display cable.
3 Replace the sensor board.
4 Replace the touch-screen board.
5 Replace the camera.
6 Turn the display-panel assembly over.
7 Route the display cable through the routing guide inside the hinge cover.
8 Align the tabs on the display-panel assembly with the slots on the display
back-cover and antenna assembly and gently snap the display-panel
assembly into place.
Post-requisites
1 Replace the display assembly.
2 Replace the wireless card.
3 Replace the battery.
4 Replace the base cover.
101
To Next Page
Loading...
