Replacing the sensor board
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer. After working inside your
computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance.
Procedure
1 Align the sensor board on the display-panel assembly and snap the
sensor board in place.
2 Slide the sensor-board cable into the connector on sensor board and
press down the latch to secure the cable.
3 Adhere the tape that secures the sensor-board cable to the sensor board.
4 Replace the screw that secures the sensor board to the display-panel
assembly.
Post-requisites
1 Follow the procedure from step 6 to step 8 in “Replacing the display
panel”.
2 Replace the display assembly.
3 Replace the wireless card.
4 Replace the battery.
5 Replace the base cover.
113
To Next Page
Loading...
