Replacing the touchpad
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Align the screw holes on the touch pad with the screw holes on the palm-rest assembly.
2. Replace the four screws (M2x2 Big Head) that secure the touch pad to the palm-rest assembly.
3. Adhere the tapes that secure the touch-pad assembly to the palm-rest assembly.
4. Slide both ends of the touch-pad cable into their respective connectors and close the latches to secure the cable.
5. Adhere the status-light board cable to the touch-pad assembly.
6. Slide the status-light board cable in to the connector on the system board and close the latch to secure the cable.
Post-requisites
1. Replace the battery.
2. Replace the base cover.
22
42 Replacing the touchpad
To Next Page
Loading...
